Dsc h50 instruction manual

Caution: The printed pattern copper foil may peel away if the heated tip is applied for too long, so be careful! Unleaded solder is more viscous sticky, less prone to flow than ordinary solder so use caution not to let solder bridges occur such as on IC pins, etc.

It is best to use only unleaded solder but unleaded solder may also be added to ordinary solder. Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

When erasing the data, execute formatting the internal memory. When replacing the SY board, erase the data in internal memory of the board before replacement. When replacing the SY board, execute formatting and initialize the internal memory after replacement.

Method for Copying the Data in Internal Memory. Method for Formatting the Internal Memory. Select [OK] with v, then press z. Copying starts. Use a fully charged battery pack. If you attempt to copy image files using a battery pack with little remaining charge, the battery pack may run out, causing copying to fail or possibly corrupting the data. You cannot select images to copy.

The original images in the internal memory are retained even after copying. You cannot choose a specific folder and copy images to it. Print order marks on the images are not copied. Note that formatting permanently erases all data in the internal memory, including even protected images. Formatting starts. Usually, the camera has been set so as to disable the data writing from the PC to the internal memory of the camera.

This setting must be changed temporarily when the data is to be written to the internal memory such as a case after the board replacement. Unleaded solder has the following characteristics. Ordinary soldering irons can be used but the iron tip has to be applied to the solder joint for a slightly longer time.

Soldering irons using a temperature regulator should be set to about Caution: The printed pattern copper foil may peel away if the heated tip is applied for too long, so be careful!

Unleaded solder is more viscous sticky, less prone to flow than ordinary solder so use caution not to let solder bridges occur such as on IC pins, etc. It is best to use only unleaded solder but unleaded solder may also be added to ordinary solder.

Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. When erasing the data, execute formatting the internal memory. When replacing the SY board, erase the data in internal memory of the board before replacement. When replacing the SY board, execute formatting and initialize the internal memory after replacement.

Method for Copying the Data in Internal Memory. Method for Formatting the Internal Memory. Select [OK] with v, then press z. Copying starts. Use a fully charged battery pack. If you attempt to copy image files using a battery pack with little remaining charge, the battery pack may run out, causing copying to fail or possibly corrupting the data. You cannot select images to copy. The original images in the internal memory are retained even after copying.

You cannot choose a specific folder and copy images to it. Print order marks on the images are not copied. Note that formatting permanently erases all data in the internal memory, including even protected images. Formatting starts.